Description:

NC Polyamide based high performance ink for Surface printing.

Application:

Packaging milk pouches.

Print Process:

CI Flexo

Print Substrate:

LDPE (minimum treatment level 38 dynes/cm), Pearlize BOPP.

Key Product Features:

High productivity due to higher press speeds than conventional inks.

Very low skin formation observed during printing.

High color strength inks resulting in better coverage than conventional inks.

Excellent deep freeze resistance (Upto -200C)*.

Recommended for press speeds more than 200 M/M.

Excellent half tone reproduction.

Suitable for food packaging.

Excellent scuff resistance.

Extremely low solvent retention/ low odor.

Excellent reproduction of halftone images even at high speeds

Good heat resistance (1600C, 3bar, 1-sec., Treated film, under standard lab conditions)

Clean and sharp images

Solvent System
Normal	IPA/Ethyl Alchol:Methoxy Propanol::9:1
Retarder	Methoxy Propanol (As required)

Shelf Life:

The inks and varnishes of this series have under normal conditions a shelf life of at least 6 months
Normal Conditions means:

Storage in tightly closed containers.

No admixtures

Temperature not exceeding 25 degree C for weeks or 30 degree C for days

Short time excessive-temperatures e.g. at transport are not harmful. The products are not sensitive to frost.
“Over-stored” inks (typical symptoms: fall in gloss, shift in shade, formation of odor and / or viscosity increase) may normally – off color being exceptions - be used the same way as residual inks by controlled admixture to fresh inks. Increased viscosity due to long-time storage of inks may generally be adjusted by addition of a slightly higher amount of thinner than the usual.

Please take note of the following :

The performance results indicated in this literature are only indicative under controlled conditions of laboratory with virgin & standard packaging grade films. Please do not use lower grades or substandard films. HFL, will not take any responsibility for abnormal results.

Liability: While the information outlined is given in good faith, it does not constitute a guarantee and neither is one implied as to the specific end use suitability of any product. The customers should always evaluate the suitability of products to their own satisfaction.

HFL is responsible only to the tune of replacing the ink consumed in case of any printing related problems clearly assigned to in-compatibility.

Remark :

Not recommended for surface printing application.
For ARSR properties, kindly inform our technical team.

Health and Safety :

Read the health and safety guidelines before using these products. The user is responsible for all local legislation requirement and packaging conditions.

Ink Handling :

Please refer to general guideline for handling inks for flexible packaging